Connect Devices; Connecting The Line To The 2-Wire Modular Pcb Connector - WAGO EnOcean RS-485 Manual

WAGO I/O System 750
750-940 EnOcean RS-485 Gateway; 868 MHz
Pos: 60 /Alle Serien (Allgemeine Module)/Überschriften/Ebene 1/Geräte anschließen - Überschrift 1 @ 3\mod_1234172889468_21.docx @ 27460 @ 1 @ 1
5

Connect Devices

Pos: 61 /Serie 750 (WAGO I/O SYSTEM)/Anschließen/Gerät anschließen 750-940 @ 36\mod_1588779391523_21.docx @ 581790 @ 22222333333 @ 1
The EnOcean Gateway is connected according to the desired operating mode.
Avoid sources with transient faults.
Do not install the EnOcean Gateway, the external antenna and the antenna line
near sources of transient faults, such as fluorescent tubes with defective starters,
frequency converters and power cables. Otherwise, communication disruptions
and incorrect values may occur.
5.1 Connecting the Line to the 2-Wire Modular PCB
Connector
The two-wire modular PCB connectors are direct plug connectors with PUSH
WIRE connections.
®
Use solid conductors only.
Only solid conductors are permitted for connecting the supply lines and voltage.
Observe the specifications in Section "Technical Data" > "Connection
Technology."
The PCB connectors are plugged onto the PCB male headers:
The line is inserted directly to the connection sockets easily and without tools:
Version 1.3.0, valid from FW/HW Version 01/01
List of Figures 39
Manual