Device Description - WAGO EnOcean RS-485 Manual

WAGO I/O System 750
750-940 EnOcean RS-485 Gateway; 868 MHz
Pos: 18 /Alle Serien (Allgemeine Module)/Überschriften/Ebene 1/Gerätebeschreibung - Überschrift 1 @ 3\mod_1233756084656_21.docx @ 27096 @ 1 @ 1
3

Device Description

Pos: 19 /Serie 750 (WAGO I/O SYSTEM)/Gerätebeschreibung (alte Struktur)/Einleitung/FT&K/Gerätebeschreibung - Einleitung 750-0940 @ 36\mod_1588776711444_21.docx @ 581720 @ @ 1
The EnOcean RS-485 Gateway 750-940 is used to integrate radio sensors into
intelligent controllers and other bus systems per
operation, control and reporting systems in building automation and to cabinet
automation systems aboard ships; it enables creation of wireless, maintenance-
free control solutions.
The module meets the standard EN 61000-6-3.
Observe intended use.
The EnOcean RS-485 Gateway 750-940 must not be used in any relation with
equipment that supports, directly or indirectly, human health or life or with
applications that can result in danger for people, animals or real value.
This arises from the module's ranking as Class 2 Equipment per ETSI EN 301
489-3 V2.1.1 (2019-03) "Specific conditions for short-range devices (SRD)."
Observe statutory provisions for operating frequency range.
The EnOcean RS-485 Gateway 750-940 868 MHz must only be operated in
compliance with the country-specific provisions regarding operation of radio
equipment.
3 modes can be configured on the EnOcean Gateway with the DIP switch to suit
a range of different applications:
• ESP3 mode:
The module functions as a gateway and is connected with a remote station
through the RS-485 interface. Communication is through a 1:1 connection
with the remote station by means of native ESP3 telegrams.
• Modbus
The module functions as a Modbus slave; it is connected to the Modbus
through the RS-485 interface. Communication with a Modbus master is
performed via the Modbus protocol. Up to ten EnOcean Gateways can be
connected in a series to a Modbus line (daisy chain topology).
• EnOcean Repeater:
The module functions as a repeater amplify and forward radio signals in an
EnOcean network.
The radio transmission can be selected as through the internal module antenna
or through a connected external antenna. The antenna is selected with a DIP
switch; see Section "Operating Elements."
In Modbus mode, the termination for the last module is switched on by default.
Switching on and off is performed with a DIP switch; see Section "Operation
mode:
®
Version 1.3.0, valid from FW/HW Version 01/01
List of Figures
ISO/IEC 14543-3-1x; e.g., to
13
Manual