Settings - Club Car Precedent 2014 Maintenance And Service Manual

IQ DISPLAY MODULE PROGRAMMER (IQDM-P):
EXCEL SYSTEM WITH ERIC CHARGING

SETTINGS

Speed Setting
The vehicle's top speed can be changed by selecting values 1 through 3 (Figure 27-4, Page 27-2). If a value of 4 is
displayed for the speed setting, a special access code has been entered to place the vehicle in "private speed mode."
A speed setting of 4 cannot be selected with the speed setting menu item. For additional information on speed setting
4, refer to Code A, Code B, and Code C. See Code A, Code B, and Code C on page 27-5.
SPEED SETTING
1
2
3
4
NOTE: Present speed values for each speed setting may be observed in the monitor menu. See Vehicle Speeds
(IQDM-P Only) on page 26-8.
Fast Accel
Fast accel (fast acceleration) is an option that can be enabled or disabled. With fast accel turned on, the vehicle will
accelerate at a noticeably faster rate. With this feature turned off, the vehicle speed will gradually increase, even if the
accelerator is quickly pressed to the floor. Turn the feature on or off by pressing "+" or "–" on the change value button.
Pedal Up Mode
Three options exist for pedal up mode (motor braking). When the accelerator pedal is released, motor braking will slow
the vehicle to "near zero speed" when pedal up motor braking is enabled (option 1 or 2). If pedal up motor braking is
disabled (option 0), the vehicle will coast to a stop when the accelerator pedal is released. See following NOTE.
Change the settings of the Pedal Up Mode by pressing "+" or "–" on the change value button.
NOTE: Pedal Up Mode does not affect top vehicle speed. When the vehicle is going down an incline, the motor
braking function will activate to prevent the vehicle from exceeding the speed setting defined in the Program
menu, regardless of Pedal Up Mode setting (0,1,2). See Speed Setting on page 27-3.
When going down an incline with the accelerator pedal partially pressed, the motor braking function will
activate to assist the operator in maintaining a speed less than the top speed setting. For example, if the
vehicle is going down an incline with the accelerator pedal pressed half way, the motor braking function
will activate to assist the operator in maintaining a speed approximately half of the speed setting defined
in the Program Menu.
PEDAL UP MODE SETTING
0
1
2
Speed Cal
The speed cal (speed calibration) menu item allows the user to fine tune the vehicle speed. This feature cannot be used
to increase the vehicle speed. The range for speed calibration is 0 to 30. Each time the number is increased, the top
speed will be decreased by 0.1 mph (0.16 km/h). The top vehicle speed will be determined by the speed setting menu
item and the speed calibration setting. For example, if the speed setting is set for a value of 2 (11.4 mph (18.3 km/h)),
and the speed calibration is set for 5, the total top speed of the vehicle should be approximately 10.9 mph (17.5 km/h).
NOTE: The SPEED CAL function will not be necessary in most golf applications since the speed setting 3 is finely
adjustable with S3 FWD SPEED. See S3 FWD Speed on page 27-4.
DESCRIPTION
Commercial speed
Slow golf speed
Normal golf speed
Private speed mode
MODE
Off
Mild pedal up
Aggressive pedal up
2014 Precedent ® Golf Car Maintenance and Service Manual
Program Menu
VEHICLE SPEED
8.0 mph (12.9 km/h)
11.4 mph (18.3 km/h)
Typical 14.8 mph (23.8 km/h). See S3
FWD Speed on page 27-4.
19.2 mph (30.9 km/h)
OPERATION DESCRIPTION
Pedal up motor braking is disabled
Mild pedal up motor braking
Aggressive pedal up motor braking
Page 27-3
27