Table of Contents
Advertisement
SECTION 14 – ELECTRICAL COMPONENTS: ELECTRIC VEHICLE
WITH POWERDRIVE CHARGER
DANGER
• See General Warnings on page 1-2.
WARNING
• See General Warnings on page 1-2.
KEY SWITCH
See General Warnings on page 1-2.
TESTING THE KEY SWITCH
See the appropriate troubleshooting section for the type of electrical system used in the vehicle.
See Excel System Troubleshooting: with PowerDrive Charger on page 13-1.
KEY SWITCH REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2.
Remove the instrument panel (Figure 14-1, Page 14-2).
2.1. Remove three screws (1) from the instrument panel (2).
2.2. Rotate the instrument panel up and away from the dash to disengage the tabs at the top of the panel.
2.3. Disconnect the electrical connector (3) to the instrument panel.
3.
Disconnect the wires from the key switch.
4.
From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the outside
of the instrument panel (Figure 14-2, Page 14-2).
KEY SWITCH INSTALLATION
1.
Position the key switch and flat washer (9) in the instrument panel, then install and tighten the switch retaining nut
(6) to 40 in·lb (4.5 N·m). Install key switch cap (8) in center dash (Figure 14-2, Page 14-2).
2.
Connect the blue and green wires to the key switch terminals. Either orientation is correct. See 13-3.
3.
Install the instrument panel.
3.1. Connect the electrical connector (3) (Figure 14-1, Page 14-2).
3.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
2014 Precedent
®
Golf Car Maintenance and Service Manual
14
Page 14-1
- Quick Links:
- Wiring Diagrams
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
