Forward/Reverse Rocker Switch Installation - Club Car Precedent 2014 Maintenance And Service Manual

14
Forward/Reverse Rocker Switch
1
705
Figure 14-4 Forward/Reverse Rocker Switch

FORWARD/REVERSE ROCKER SWITCH INSTALLATION

1. Route the three wires through bezel. Connect the blue (4), orange (5) and brown (6) wires to the rocker switch
(3), exactly as shown in (Figure 14-4, Page 14-4).
2. Orient the rocker switch (3) so the terminals are towards the front of the housing (1). Push rocker switch (3)
into housing (1).
3. Place the housing in position on the body and install the two screws (2). Tighten to 20 in·lb (2.3 N·m).
4. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation.
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is
in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch
is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
Page 14-4 2014 Precedent
3
4
5
6
® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLE WITH POWERDRIVE CHARGER