Canopy (Monsoon Version) - Four-Passenger; Monsoon Canopy Removal; Monsoon Canopy Installation - Club Car Precedent 2014 Maintenance And Service Manual

4
Canopy (Monsoon Version) – Four-Passenger
CANOPY (MONSOON VERSION) – FOUR-PASSENGER
See General Warnings on page 1-2.
CAUTION
• To prevent damage to the canopy, do not remove the canopy supports (1, 2, 8 and 9) from the vehicle
without first removing the canopy (13) (Figure 4-19, Page 4-27).

MONSOON CANOPY REMOVAL

1. Remove the two flanged lock nuts (17), four rubber faced conical washers (20), and two bolts (15) from the
canopy (13) at each front strut (8 and 9) (Figure 4-19, Page 4-27).
2. Remove the four bolts (18) from the canopy (13) at each rear drain strut (1 and 2).
3. Lift canopy (13) off the canopy struts.
4. Remove screws (12) securing front strut covers (11) to front body.
5. Slide front strut covers (11) up front canopy supports (8 and 9) to gain access to bolts (10).
6. Remove two bolts (10) from each front strut (8 and 9) and remove the struts from the vehicle.
7. Remove the four nuts (7) and four bolts (5) securing each rear drain strut (1 and 2) and remove the struts
from the vehicle (Figure 4-17, Page 4-25).

MONSOON CANOPY INSTALLATION

1. Secure the rear canopy supports.
1.1. Position each rear canopy support (1 and 2) to the side of the seat support assembly (3) as shown (Figure
4-17). Make sure the bottom of the strut is in the hole (4) in the rear body to allow for water drainage.
1.2. Loosely secure each rear drain strut (1 and 2) to the seat support assembly with two hat brackets (6) with
four M6x1 x 25 hex head bolts (5), and four M6 nylon lock nuts (7). Make sure the lower hat bracket (6) is
between the two locating tabs (8) on each rear strut. Finger tighten the hardware at this time.
Page 4-24 2014 Precedent ® Golf Car Maintenance and Service Manual
BODY AND TRIM