Tow/Run Switch; Testing The Tow/Run Switch; Tow/Run Switch Removal; Tow/Run Switch Installation - Club Car Precedent 2014 Maintenance And Service Manual

14

Tow/Run Switch

707
TOW/RUN SWITCH
See General Warnings on page 1-2.

TESTING THE TOW/RUN SWITCH

See Test Procedure 6 – Tow/Run Switch on page 13-19.

TOW/RUN SWITCH REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove the bolt (11) that secures the electronics module to the battery bucket (Figure 14-8, Page 14-11).
3. Pull electronics module forward and disconnect the pink wire (3) and light green wire (4) from switch.
4. Remove Tow/Run switch boot/hex nut (1) (Figure 14-6, Page 14-7).
5. Remove Tow/Run switch (2) from electronics module.

TOW/RUN SWITCH INSTALLATION

1. Installation is reverse of removal. Make sure flat on switch is aligned with flat part of D-shaped hole in electronics
module (Figure 14-6, Page 14-7). Tighten Tow/Run switch boot/hex nut (1) to 16 in·lb (1.8 N·m).
2. Connect the wires to the switch.
Page 14-6 2014 Precedent
1
Figure 14-5 Access and Remove Electronics Module Cover
® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLE WITH POWERDRIVE CHARGER
2
4
3
5