Charger Receptacle Removal; Charger Receptacle Installation - Club Car Precedent 2014 Maintenance And Service Manual

29
Charger Receptacle

CHARGER RECEPTACLE REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove kick plate. See Kick Plate and Charger Receptacle Bezel on page 4-9.
3. Remove the 10-gauge red wire from the solenoid .
4. Disconnect the 10-gauge black wire from the controller B- terminal.
5. Disconnect the light blue wire from main harness at the bullet connector.
6. Remove the three screws (1) that secure the charger receptacle (2) to the bucket.

CHARGER RECEPTACLE INSTALLATION

1. Insert the wires through the hole in the bucket .
2. Insert receptacle (2) into bucket.
3. Install the three screws (1) that secure the receptacle to the bucket. Tighten screws to 16 in·lb (1.8 N·m).
4. Connect 10-gauge red wire to solenoid. Tighten nut 72 to 84 in·lb (8 to 9.5 N·m).
5. Connect 10-gauge black wire to controller B- terminal. Tighten bolt to 108 in·lb (12.2 N·m).
6. Connect light blue wire to main harness at bullet connector with light blue wire.
7. Install kick plate. See Kick Plate and Charger Receptacle Bezel on page 4-9.
8. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
Page 29-14 2014 Precedent ® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLE WITH ERIC CHARGING