Drive Clutch Installation - Club Car Precedent 2014 Maintenance And Service Manual

25
Drive Clutch
14. Compress each take-up spring and install the drive button over the rib and take-up spring (Figure 25-10, Page
25-9).
15. Install a no. 10-24 button retaining screw with flat washer through each button and into the rib. Tighten the
screws to 34 in·lb (3.8 N·m) (Figure 25-11, Page 25-9).
16. Install the thrust washer (11) onto the moveable face assembly (Figure 25-7, Page 25-7).
17. Install the hub assembly (8) on the moveable face assembly and align the match marks made before
disassembling the clutch. Press the hub assembly on by hand.
18. Replace the three plastic plugs (22) into the hole protectors (Figure 25-7, Page 25-7).
607

DRIVE CLUTCH INSTALLATION

1. Place the drive clutch assembly on the crankshaft taper. Position the mounting washer (19) on the bolt (17) and
start the bolt into the crankshaft (Figure 25-7, Page 25-7). See following NOTE.
NOTE: The drive clutch retaining bolt has left-hand threads. The manufacturer recommends replacing the drive clutch
retaining bolt (PN 103345701) when installing the drive clutch. If a new bolt is not available, clean the threads
of the original bolt and apply Loctite
2. Tighten the drive clutch retaining bolt (17) to 25 ft·lb (33.9 N·m) (Figure 25-7, Page 25-7).
3. Install the starter/generator belt and adjust belt tension as instructed. See Belt Tension Adjustment on page
20-11. Tighten the starter/generator mounting hardware to 23 ft·lb (31.2 N·m) and the adjusting hardware to
13 ft·lb (17.6 N·m).
4. Lower vehicle to the height required to position the leaf springs in the mounting shackles. Install the mounting
bolts and lock nuts. Tighten lock nuts to 15 ft·lb (20.3 N·m) (Figure 25-17, Page 25-13).
5. Position shocks in the shock mounts and install cushions, mounting washers, and nuts (Figure 25-18, Page
25-13). Tighten nuts until cushions expand to be the same diameter as the mounting washers.
Page 25-12 2014 Precedent
Figure 25-16 Correct Orientation of Drive Button Take-up Springs
® 242 to the threaded end prior to installation.
® Golf Car Maintenance and Service Manual
TORQUE CONVERTER (GASOLINE VEHICLE)