Canopy - Two-Passenger; Two-Passenger Canopy Removal - Club Car Precedent 2014 Maintenance And Service Manual

Table of Contents

Advertisement

BODY AND TRIM
Rear Beauty Panel Installation
1.
Install rear beauty panel (12) on vehicle. Make sure body clips (17) on the rear of the beauty panel engage
the slots in the rear underbody (4) (Figure 4-11, Page 4-15). Secure beauty panel in place with four screws
(13). Tighten screws to 44 in·lb (5 N·m).
2.
Connect the three wires to the Forward/Reverse switch (16) as shown.
3.
Position the Forward/Reverse switch housing (15) on the front of beauty panel (12) and secure with two screws
(14). Tighten screws to 20 in·lb (2.3 N·m).
4.
Install seat support. See Seat Support Installation on page 4-17.
Access Panel
Access panel (6) is secured to the rear underbody (4) with two push rivets (7) (Figure 4-11, Page 4-15).
Rear Underbody Removal
1.
Remove four screws (5) attaching the rear underbody (4) to vehicle (Figure 4-11, Page 4-15).
2.
Lift the rear edge of the rear underbody (4) until the front portion slides out from beneath the front underbody.
Remove the rear underbody from the vehicle.
Rear Underbody Installation
Install rear underbody (4) on the vehicle (Figure 4-11, Page 4-15). Install four screws (5) to secure the underbody
to the vehicle. Tighten screws (5) to 71 in·lb (8 N·m).
CANOPY – TWO-PASSENGER
See General Warnings on page 1-2.
CAUTION
• To prevent damage to the canopy, do not remove the canopy supports (3, 7, and 10) from the vehicle
without first removing the canopy (1) (Figure 4-15, Page 4-20).

TWO-PASSENGER CANOPY REMOVAL

1.
Remove the two nuts (9) and two bolts (8) from the canopy (1) and each front canopy support (7 and 10) (Figure
4-15, Page 4-20).
2.
Remove the nuts (5) and bolts (4) from the canopy (1) and each rear support (3).
3.
Lift canopy (1) away from front canopy supports (7 and 10) and rear supports (3).
4.
Remove screws (14) securing front canopy support covers to front body.
5.
Slide canopy support covers (12 and 13) up front canopy supports (7 and 10) to gain access to bolts (11).
6.
Remove two bolts (11) from each front canopy support (7 and 10) and remove canopy supports from the vehicle.
7.
Remove bolt (6) from each rear support (3) and pull rear supports from vehicle.
2014 Precedent
®
Golf Car Maintenance and Service Manual
Canopy – Two-Passenger
Page 4-19
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents