Battery Care - Vehicles Without The Single-Point Watering System - Club Car Precedent 2014 Maintenance And Service Manual

15
Battery Care
on page 10-4. If a valve fails to open, the cell will eventually dry out. The initial one-time inspection of all cells
will identify any occurrence of a valve that fails to open. If a valve fails to close, it will become evident due to
the cell overflowing during routine watering. Either failure scenario is rare, but should be monitored in the initial
inspection and during routine watering sessions. Replace malfunctioning valves to ensure maximum battery
life. See following CAUTION.
CAUTION
• After checking the electrolyte, fully tighten the battery caps to prevent electrolyte leakage.
2. After the initial six-week inspection, manually check the electrolyte level at least once per year, particularly after
long-term storage or any other period of vehicle inactivity. See preceding CAUTION.
BATTERY CARE – VEHICLES WITHOUT THE SINGLE-POINT WATERING SYSTEM
To keep batteries in good working condition, follow this maintenance program on a regular basis:
1. Keep the batteries clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking
soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off of the batteries. Do
not allow this solution to enter the battery. Be sure terminals are tight. Let the terminals dry and then coat with
Battery Terminal Protector Spray (CC P/N 1014305). See following NOTE.
NOTE: Dispose of waste water properly.
2. Check the electrolyte level weekly (Figure 15-5). Add water only after charging unless the electrolyte level is
below the top of the plates. In this case, add just enough water to cover the plates, charge, and then check the
level again. Never charge batteries if plates are exposed above electrolyte level. For best battery life, add only
distilled water. See following CAUTION and NOTE.
CAUTION
• Do not overfill the batteries.
NOTE: A battery watering gun or bottle is available at many auto parts dealers.
3. The battery hold-downs should be tight enough so that the batteries do not move while the vehicle is in motion,
but not so tight as to crack or buckle the battery case. For 8-volt batteries, tighten hold-down retaining nuts to
106 in·lb (12 N·m). The terminal connections should be clean and tight, and any worn insulation or frayed wires
should be replaced. Tighten battery terminals to proper torque. See Connecting the Batteries – Electric
Vehicles on page 1-4. See following WARNING.
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to
do so may cause them to overheat during operation and could result in fire, property damage, or
personal injury.
4. After use, charge the batteries. The batteries should never be left discharged any longer than absolutely
necessary (do not leave discharged overnight).
Page 15-12 2014 Precedent ® Golf Car Maintenance and Service Manual
BATTERIES: ELECTRIC VEHICLE WITH
POWERDRIVE CHARGER