Reverse Buzzer; Testing The Reverse Buzzer; Reverse Buzzer Removal; Reverse Buzzer Installation - Club Car Precedent 2014 Maintenance And Service Manual

14

Reverse Buzzer

3. Connect the two-pin and three-pin connectors from the wire harness to the MCOR3.
4. Install the pedal group. See Pedal Group Installation on page 5-3.
5. Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-4.
REVERSE BUZZER
See General Warnings on page 1-2.

TESTING THE REVERSE BUZZER

See Test Procedure 24 – Reverse Buzzer on page 13-36.

REVERSE BUZZER REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove instrument panel. See Key Switch Removal on page 14-1.
3. Disconnect the 18-gauge pink and orange/white wires from reverse buzzer.
4. Remove the two screws from the reverse buzzer. Remove the reverse buzzer from the dash panel.

REVERSE BUZZER INSTALLATION

1. Install the reverse buzzer in the reverse order of removal. Pink wire must be connected to the positive terminal.
Tighten screws to 4 in·lb (0.45 N·m).
2. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
Page 14-8 2014 Precedent ® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLE WITH POWERDRIVE CHARGER