Process-Related Faults And Messages - Miele PG 8583 CD Operating Instructions Manual

Problem solving guide
Problem
Fault 578

Process-related faults and messages

Problem
Change the coarse filter
Change the HEPA filter
Drying during program
deactivated
Wrong code entered
Test program: Test object
can now be removed
Program cancelled
140
Possible cause and solution
The peak-load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy

management system tested by a suitably qualified
person.
Possible cause and solution
The maximum permissible operating hours for the coarse
filter have been reached.
Replace the coarse filter with a new one.

Reset the operating hours counter for the coarse filter.

The maximum permissible operating hours for the HEPA
filter have been reached.
Replace the HEPA filter with a new one.

Reset the operating hours counter for the HEPA filter.

Drying cannot be selected at the start of a program
because drying is not available for the selected program.
Start the program without drying.

Or
Have the drying parameters for this program adjusted by

Miele Service.
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to Miele Service.

This is not a fault.
A test program is running to check performance. At certain
points in the program the sequence is interrupted so that
samples can be taken.
Take a sample.

or
Wait. The program will continue automatically in approx.

30 seconds.
or
Continue the program without delay by pressing the

Start/Stop button.
This is not a fault.
A program which was running was cancelled by the user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and process
chemicals can escape. Protective measures for personal
safety must be observed.