Installation; Installation And Levelling - Miele PG 8583 CD Operating Instructions Manual

Installation

152

Installation and levelling

Please refer to the installation diagram provided.
 In order to reduce the risk of water damage, the area around the
machine should be limited to furniture and fittings that are designed
for use in commercial environments.
The machine must be stable and horizontal.
Any unevenness in the floor level can be compensated for by
adjusting the two front feet. The feet can be screwed out to a
maximum of 80 mm (1/3 in).
With the feet screwed in the appliance can be rolled backwards or
forwards on fitted castors. To do this the appliance must be raised up
slightly at the front.
 Do not lift the appliance by the control panel or the drawer in
the side unit.
This could damage them.
 Some metal parts pose a risk of injury/being cut.
Wear cut-resistant protective gloves when transporting and setting
up the machine.
 For transport by means of a hand truck, the machine must be in
its original packaging or placed on a stable, continuous support.
Otherwise, components in the base of the machine can be
damaged.
The machine is suitable for the following types of installation:
- Freestanding.
- Slot-in:
The machine can be installed beside other appliances or furniture
or in a suitable niche. The niche must be at least 900 mm wide and
700 mm deep.
- Built-under:
The machine can be built under a continuous worktop. The space
provided must be at least 900 mm wide, 700 mm deep and
820 mm high.