Process-Related Faults And Messages - Miele PG 8593 Operating Instructions Manual

Problem
Fault 578

Process-related faults and messages

Problem
Fit a new HEPA filter!
Drying during programme de-
activated
Wrong code entered
Test programme: test object
can now be removed
Programme cancelled
Cause and remedy
The peak load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy

management system tested by a suitably qualified
person.
Cause and remedy
The maximum permissible operating hours for the HEPA
filter have been reached.
Replace the HEPA filter with a new one.

Reset the operating hours counter for the HEPA filter.

Drying cannot be selected at the start of a programme
because drying is not available for the selected
programme.
Start the programme without drying.

Or:
Have the drying parameters for this programme adjusted

by the Miele Customer Service Department.
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to the Miele Customer

Service Department.
This is not a fault.
A test programme is running to check performance. At
certain points in the programme the sequence is
interrupted so that samples can be taken.
Take a sample.

or
Wait. The programme will continue automatically in

approx. 30 seconds.
or
Continue the programme without delay by pressing the

Start/Stop button.
This is not a fault.
A programme which was running was cancelled by the
user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
Problem solving guide
141