Process-Related Faults And Messages - Miele PG 8581 Operating Instructions Manual

Problem solving guide

Process-related faults and messages

Problem
Drying during program
deactivated
Wrong code entered
Test program: Test object
can now be removed
Program cancelled
Program continued
Peak load cut-out
All settings reset
All program settings reset
118
Possible cause and solution
Drying cannot be selected at the start of a program
because drying is not available for the selected program.
Start the program without drying.

Or
Have the drying parameters for this program adjusted by

Miele Service.
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to Miele Service.

This is not a fault.
A test program is running to check performance. At certain
points in the program the sequence is interrupted so that
samples can be taken.
Take a sample.

or
Wait. The program will continue automatically in approx.

30 seconds.
or
Continue the program without delay by pressing the

Start/Stop button.
This is not a fault.
A program which was running was cancelled by the user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and process
chemicals can escape. Protective measures for personal
safety must be observed.
This is not a fault.
The process of cancelling a program was not completed.
The program which was running continued without
interruption.
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
This is not a fault.
A user has restored factory default settings.
Confirm the message with OK.

This is not a fault.
A user has restored the factory default setting for the
program.
Confirm the message with OK.
