Building Under A Continuous Worktop; Prevent Heat Build-Up - Miele PG 8583 CD Operating Instructions Manual

Installation
Steam condenser
Protective foil/
countertop
protector
Prevent heat
build-up
Securing to the
countertop
Venting the
circulation pump
154

Building under a continuous worktop

To avoid steam damage to the worktop, the protective foil supplied
(25 x 58 cm, self-adhesive) must be applied underneath the
worktop in the area of the steam condenser.
The protective foil supplied protects the countertop from damage
caused by steam when the door is opened. It should be positioned
underneath the countertop above the machine door.
During the drying phase hot exhaust air is discharged from the wash
cabinet through the steam condenser on the back of the machine. To
avoid heat build-up and excessive condensation, sufficient air
circulation must be ensured.
Leave at least 10 mm (0.39 in) space between machine and

worktop for air circulation.
Install ventilation grills in the side cabinets if necessary.

To improve stability, the machine must be secured to the countertop
after it has been aligned.
Open the door.

Screw the machine to the continuous countertop through the holes

in the front trim on the left and right.
Please contact Miele Service to secure it at the sides to adjacent
cabinetry.
 The gaps between a built-in machine and adjacent cabinetry
must not be sealed, e.g., with silicone sealant, as this could
compromise ventilation of the circulation pump.