Process-Related Faults And Messages - Miele PG8582 CD Operating Instructions Manual

Problem
Fault 550
Fault 555
Fault 559
Fault 578

Process-related faults and messages

Problem
Change coarse filter
Change HEPA filter
Drying during programme
deactivated
Cause and remedy
The waterproof system has been activated. One of the
water intake hoses might have a leak.
Close the stopcocks.

Contact the Miele Service Department.

Too much water has accumulated in the steam condenser.
Restart the machine. Excess water is pumped out

automatically.
There is a problem with the process documentation
interface. The machine has detected a module for an
Ethernet interface, but only a serial interface (RS232) is
activated in the controls.
Deactivate the RS232 interface:
Open the menu for configuring the interface

settings Interface
/
Wait approx. 90 seconds. The Ethernet module XKM

3000 L Med needs this time for initialisation. It may be
necessary to reconfigure the interface.
Or
Replace the Ethernet module XKM 3000 L Med with a

XKM RS232 10 Med module to set up a serial interface.
The peak-load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy

management system tested by a suitably qualified
person.
Cause and remedy
The maximum permissible operating hours for the coarse
filter have been reached.
Replace the coarse filter with a new one.

Reset the operating hours counter for the coarse filter.

The maximum permissible operating hours for the HEPA
filter have been reached.
Replace the HEPA filter with a new one.

Reset the operating hours counter for the HEPA filter.

Drying cannot be selected at the start of a programme
because drying is not available for the selected programme.
Start the programme without drying.

or
Have the drying parameters for this programme adjusted

by Miele Service.
Problem solving guide
Ethernet
and then select
Further
.
133