Electrical Connection; Equipotential Bonding Connection - Miele PG 8583 CD Operating Instructions Manual

Electrical connection

156
 All electrical work must be carried out by a suitably qualified
electrician.
- The electrical installation must be in compliance with current local
and national safety regulations (DIN VDE 0100 in Germany).
- The connection to the power supply must comply with national
regulations. The socket must be accessible after the machine has
been installed. An electrical safety test can then easily be carried
out, e.g., after any service or maintenance work.
- If the machine is hard-wired to the power supply, a power switch
capable of disconnecting the machine at all poles must be
installed. This power switch must be designed to operate at the
rated current, have a contact gap of at least 3 mm, and also be
lockable in the off position.
- If necessary, equipotential bonding must be carried out.
- The rated loads are specified on the data plate and in the wiring
diagram supplied with the machine.
- For increased safety, it is recommended to protect the machine
with a 30 mA residual current device (RDC).
- If replacing the power cable, use only original replacement parts
from the manufacturer or a suitable cable with core cable ends.
Further notes on electrical connection are given on the Installation
diagram supplied with the machine.
The machine must only be operated with the voltage, frequency and
fusing shown on the data plate.
This appliance can be converted to a different type of power
supply in accordance with the conversion diagram and wiring
diagram supplied.
A data plate can be found on the inside of the door and another on
the back of the machine.
The wiring diagram is supplied with the machine.

Equipotential bonding connection

There is a screw connection point marked  at the back of the
machine, to which additional equipotential bonding can be
connected.