Activating
conductivity
measuring
Set limit value
Conductivity measuring is activated individually for each program.
Conductivity is measured in the final rinse phase.
...
Conductivity limit
Conductivity limit
Water intake
Water drainage
Water intake
-
The electrical conductivity of the water before the beginning of the
final rinse phase is measured.
-
Water drainage
The electrical conductivity of the water at the end of the final rinse
phase is measured.
Select an option using the and arrow buttons.
Press OK to save the setting.
Following selection a maximum limit value for electrical conductivity
must be set.
The limit values for
individually.
...
Conductivity limit
Water intake
Set
Water intake
--
µS/cm
(5 - 200 µS/cm )
Adjustment is in increments of 1. The possible range is shown in the
bottom line.
Use the arrow buttons (higher) and (lower) to set the limit
value.
Touch OK to save the limit value.
Water intake
and
Water drainage
Water drainage
or
Program settings
are set
Water drainage
--
µS/cm
(5 - 200 µS/cm )
105