Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
Program sequence indicator
After the program has started, the program sequence can be followed
in the three-line display.
Universal
Main wash 1
Time left
- Program name.
The following parameters can be checked using the arrow buttons
and :
- Current program block, e.g.
- Actual or required temperature
(depending on the display set, see "Further settings/Display:
Temperature"),
- A
value,
0
- Conductivity
(only for machine version with conductivity meter),
- Cycle number,
- Time left (in hours; under an hour, in minutes)
End of program
A program is usually finished when the following parameters and
messages are shown in the display:
- Program name.
Continuously alternating between:
- Parameter met/not met,
- A
value,
0
- Conductivity in final wash block
(only for machine version with conductivity meter).
- Cycle number,
- Program finished.
In addition, the LED in the Start/Stop buttons goes out and the LED in
the button begins to flash. In the factory default state, an acoustic
tone also sounds for approx. 10 seconds (see "Settings/Volume").
25
Min
Main wash 1
,
Operation
57