Altering A Program; Allocating Wash Blocks - Miele PG 8583 CD Operating Instructions Manual

Allocating wash
blocks

Altering a program

You can alter all parameters which are identified as changeable in the
program charts. Other settings can only be altered by Miele Service.
A program setting is altered in two steps:
- First the wash blocks must be reallocated to the program or the
existing allocation confirmed again. Only allocated program blocks
can be parameterized.
- Then the program parameters can be altered.
Document all changes of factory settings in case of a subsequent
Service call.
Changing program parameters on a validated machine will
necessitate a renewed performance validation.
...
 Program settings
Change program

Change program
Select the program you want to alter.

For more information see "Allocating wash blocks".
For every program change the wash blocks must first be allocated.
Universal
Accept
Allocation is by multiple choice. A box is shown next to all wash
blocks in the display. If a wash block is allocated to the program,
there is a tick  in the box. This wash block is allocated to the
program by ticking the box or the allocation can be removed by
removing the tick.
The wash blocks can be selected or deselected using the  and 

arrow buttons and confirming with OK.
To save the selection, select the

and confirm with OK.
If you want to adopt the preset wash blocks without any changes,

you can confirm the
The further setting options will then follow. You can edit these in any
order you want.
Universal
Standard
Pre-rinse 1
Accept
Accept option immediately with OK.
Program settings
option at the end of the list
101