Cancel With Fault Number - Miele PG 8583 CD Operating Instructions Manual

Problem solving guide

Cancel with fault number

If a program is cancelled and a fault number appears, e.g.
a number), there could be a serious technical fault.
In the event of a program being cancelled and a fault number being shown:
Switch the machine off using the  button.

Wait approximately 10 seconds before switching the machine on again with the

 button.
Acknowledge the fault number by entering your PIN code.

Start the previously selected program again.

If the same error message appears again:
Make a note of the error message.

Switch the machine off using the  button.

Contact Miele Service.

Please also read the notes regarding the following fault numbers.
Problem
Fault 403-405
Fault 406–408
Fault 412–414
Fault 422
136
Possible cause and solution
A program has been canceled because water intake by the
machine was insufficient or severely restricted.
Turn on the faucets fully.

Follow the further information provided in the

water intake
message.
A program was cancelled because the water flow rate is
insufficient.
Check whether the faucets are fully open.

Refer to the information regarding minimum flow

pressure in "Connection to the water supply" and
"Technical data".
Check the filter in the water inlet.

Contact Miele Service for advice.

A program was cancelled because the water flow rate is
too high.
Refer to the information regarding recommended

maximum flow pressure and maximum permissible static
water pressure in "Connection to the water supply" and
"Technical data".
Contact Miele Service for advice.

The salt supply in the water softener has been used up.
Reactivation is no longer possible. The machine will be
locked for further use with the next reactivation.
Refill with reactivation salt.

Fault XXX
(where XXX represents
Check