Networking Ki Pro Ultra Using The Factory Default Ip; Controlling Ki Pro Ultra From A Web-Browser - AJA Ki Pro Ultra Installation & Operation Manual

Networking Ki Pro
Ultra using the
Factory Default IP
Controlling Ki Pro
Ultra from a web-
browser
Ki Pro Ultra v1.2r1
For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses using the User Control
NOTE:
Knob and the Alphanumeric Keypad. Then you will click on SAVE to keep your entries.
Figure 8. Ki Pro Ultra User Interface Alphanumeric Keypad
If you don't want to use DHCP to network Ki Pro Ultra and also don't want to set your own
static IP address, you can simply use a Default setting to use a factory setting of
10.65.74.65. This is useful for quickly connecting directly to a laptop or computer. Here
are the steps to set this up:
1. Use the User Control Knob to navigate to parameter "50.1 IP CONFIG", push the knob
to enter the menu, then scroll to select "Default".
2. Set your laptop or desktop computer Ethernet IP address to 10.m.n.m (where m is
not 65 and n is not 74).
3. Also on the computer, set the Subnet mask to 255.0.0.0 (most PCs default to the
proper netmask when the address is set—so you may not have to change it).
4. Run a browser on the computer and type 10.65.74.65 (the Default factory IP
address). You should now see Ki Pro Ultra's browser status screen.
To control Ki Pro Ultra from a web browser on a network attached computer, you must
enter Ki Pro Ultra's IP address as a URL in the browser. For example, if Ki Pro Ultra's IP
address were 10.0.6.31, you would then type into the web browser: http://10.0.6.31
This topic is explained in greater detail in "Browser Remote Control" on page
28
60.
www.aja.com