Throttle Mixing (Throttle Mix) - RadioLink AT9S PRO Manual

Be careful not assign governor off to a condition switch if you
want the governor to function in that condition.
• Speed switching and governor ON/OFF may be together using one switch or ON/OFF switching may be
performed using an independent switch/channel.
• When speed setting control uses CH7 and separate ON/OFF switch is not used, CH8 can be used for other
functions.
• In-flight adjustment of the head speed (for easy adjustment during turning) may be created using an
additional channel and a programmable mix.
The GV-1 controls throttle when it is active, so the throttle will not obey any Failsafe settings preset for
throttle in the transmitter. Always set the Failsafe setting for the GV-1's on/off channel to OFF. This way the
governor is shut off and the throttle obeys the Failsafe throttle commands.
Goals
Set up a governor to
use
both channels into the
receiver and switch between
the governor settings
automatically when changing
conditions. Consider setting
the battery Fail Safe settings
and other helpful functions
on the governor itself.

5.3.10 Throttle Mixing (THROTTLE MIX):

This function can be set for each flight condition, and is used
to correct the tendency of the model to change altitude when
the rotor is tilted by aileron, elevator, and rudder controls.
Adjustability:
• Mixing may be set from 0 to 100% each flight condition.
Steps
Open and activate the
GOVERNOR Function.
Activate the function.
O pt i o na l: c h an ge c u t- of f
c ha n ne l to channel 8 and
assign switch and direction
for on/off (channel 8).
Optional: Changes switch
assignment to select
governor settings.
E x : s e l e c t s w i t c h t h a t
s e l e c t s t h e conditions.
Adjust governor speed
settings per switch position
or condition as needed.
(Ex: defaults are fine.)
Allows head speed
adjustment from transmitter.
Close
73
Radiolink Electronic Ltd
Inputs
to BASIC menu,
ADVANCE
to GOVERNOR
to MIX to ACT.
，
to -cut- CH:
，
to -cut-SW
，
to SW to Cond，
，
to each Cond position
needed.
to next Cond，repeat .
www.radiolink.com
again to
to+CH8，
to desired SW
or as