Epa - RadioLink AT9S PRO Manual

Adjustable travel limit (ATL)
Make the channel 3 TRIM LEVER (THROTTLE TRIM) effective only at low throttle, and disabling the trim at
high throttle. This prevents pushrod jamming due to idling trim changes. This function defaults to ON. If you are
not using channel 3 for throttle, you may want trim operation the same as on all other channels. To do so, set
ATL to OFF. If you need the ATL to be effective at the top of the stick instead of the bottom, reverse the
THR-REV setting. Note that this affects all models in the radio, not just the model you are currently editing.
Goals
Change ATL from ON
to OFF for battling
robots, tanks,
airbrakes and other
channel 3 uses.
Home screen display
As shown below, home screen will display plane type and throttle pitch:
ILLUST: displays the illustration of helicopter in the home screen. (Default)
THR/PIT: displays the current throttle and pitch position in the home screen.
Step to change plane type image to THR/PIT: under model type helicopter, enter basic menu, choose
MODEL TYPE, and enter HOME DISP, press PUSH, then DIAL to THR/PIT, then press PUSH.
2.3.3 End Point of servo travel adjustment (END POINT, also called EPA)
The most flexible version of travel adjustment is available. It independently
adjusts each end of each individual servo's travel, rather than one setting for
the servo affecting both directions. Again, for CCPM helicopters, be sure to
see SWASH AFR prior to adjusting end points.
Adjustability:
• Can set each direction independently.
• Ranges from 0% (no servo movement at all) to 140%. At a 100% setting,
the
Throw of the servo is approximately 40° for channels 1-4 and approximately 55° for channels 5-8.
• Reducing the percentage settings reduces the total servo throw in that direction.
Examples:
• Adjust the throttle high end to avoid binding at the carburetor, and low end to allow for proper carburetor
closure.
• END POINT may be adjusted to 0 to keep a servo from moving one direction, such as flaps not intended to
Steps
Open Basic menu,
then to Mode Type.
Go to ATL and
change. (Ex: to OFF)
Close
Inputs
Mode for 1s (If ADVANCE, Mode again).
Mode TYPE, press PUSH.
to ATL, to OFF.
17
Radiolink Electronic Ltd
www.radiolink.com
To