Prog.mix - RadioLink T8S User Manual

AUX-CH
CH5/6/7/8 can be personalized to different switches. If any of the auxiliary channels is not for use, NULL should
be set.
TX-ALARM
The default low voltage value is 3.7V, which can be personalized as well. When the transmitter voltage is lower
than the value set, T8S will make D sound to warn.
STK-MODE(SYSTEM)
It's always the default mode of the T8S with data READ by the APP.
Mode 1: left joystick-Rudder and Elevator; right joystick-Aileron and Throttle
Mode 2: left joystick-Rudder and Throttle, right joystick-Aileron and Elevator
Mode 3: left joystick-Aileron and Elevator, right joystick-Rudder and Throttle
Mode 4: left joystick- Aileron and Throttle, right joystick-Rudder and Elevator
VERSION (Under STK-MODE,SYSTEM)
The numbers mean current firmware versions which can be upgraded. The detailed steps of firmware upgrade
please refer to Chapter 2.
Note The other version on the right (above SYSTEM2) is the APP version.
EXT-ALARM(SYSTEM2)
To return the model voltage, RadioLink receivers of telemetry functions R7FG or R8F should be used. The low
voltage alarm value can be personalized. When the model voltage goes lower than the set value, T8S will
make D sound to warn.
* This function is currently available on Android APP V7.1 and above.
RSSI-ALARM(SYSTEM2)
The RSSI alarm value can be personalized. When the RSSI goes lower than the set value, T8S will make D
sound to warn.
* This function is currently available on Android APP V7.1 and above.

3.3.4.1 PROG.MIX

Programmable mixing controls are to
Diversify attitude changes of aircraft (e.g. Rolling to realize when rudder is commanded);
1
Control a certain axis with two or more servos (e.g. 2 rudder servos);
2
Correct special movement automatically (e.g. Lower FLAP and ELEVATOR servos at the same time);
3
Control the second channel to respond to the movement of the first channel (e.g. Increase smoke oil
4
to respond to high speed, but only when the smoke switch is activated).;
Turn off the main control under certain circumstances (e.g. For dual-engine aircraft, turn off a motor or
5
speed up/down one motor to assist rudder to turn)
Adjustability: Channel 1 to 8 can be personalized to mix.
MAS: Master channel. Other channels need to cooperate with movements of the master channels.
SLA: Slave channel. Many mix controls are controlled by one master channel.
E.g. Rudder-Aileron mix control with Master as rudder while Slave as aileron and OFFS as 0 and UP as 25% to
correct rolling. No switch is needed.
THROTTLE CUT Setup
This function is achievable with T8S programmable mix controls setting.
In SYSTEM Menu, turn on the Mix Control, set Master as CH1 while Slave as CH8 with the OFFS value as
-100. Then in ADVANCED Menu, turn on the D/R MIX function, set CH as CH3 and the DOWN value as 0.
Then toggle the CH8 Toggle-Switch to the right most and the setting is complete.
10
Radiolink Electronic Ltd
www.radiolink.com