Camber Mixing; Butterfly (Crow) Mixing - RadioLink AT9S PRO Manual

4.3.7 Camber Mixing:

This function adjusts the mixing rate of camber operation which
operates the wing camber (ailerons and flaps) in the negative and
positive directions. The aileron, flap, and elevator rates can also be
adjusted independently and attitude changes caused by camber
operation can be corrected.
Also the operation reference point of camber control can be offset.
(PRE)
Note: Camber control is not assigned at initial.
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%,
with a default of 0%.
Goals
Ex: set the mixing
amount for aileron
to 40%, camber
control to VR (E),
reference point to
desired point.

4.3.8 BUTTERFLY (crow) mixing

BUTTERFLY simultaneously moves the flaps, twin ailerons and elevator, and is usually used to make steep
descents or to limit increases in airspeed in dives. Separate two BUTTERFLY settings are available.
(CRI1/CRI2)
Adjustability:
• Activation: Get proportional by moving the THROTTLE STICK.
Steps
Open the CAMBER MIX
function.
Choose desired slider.
Adjust the mixing amount for
AILE. (Ex: adjust to 40%)
Set the reference point.
Close
Inputs
to BASIC .
to CAMBER-MIX,
to VR to VrA
，
to FLP
to VrA
，
to VrA ，
to PRE or
，
point for 1 sec.
56
Radiolink Electronic Ltd
www.radiolink.com
again to ADVANCE
to 40%,
to 40%，
VrA to desired