Compatible Receiver - RadioLink AT9S PRO Manual

SWITCH ASSIGNMENT TABLE
• The factory default functions activated by the switches and knobs for a AT9S Pro transmitter are
shown below.
• Most AT9S Pro functions may be reassigned to non-default positions quickly and easily.
Always check that you have the desired switch assignment for each function during set up.
Switch/Knob Airplane ( ACRO )
A or H
SWITCH A elevator dual rate
ch10
SWITCH B rudder dual rate
ch9
SWITCH C up = ELE-FLP on
center/down=
IDLE-DOWN
down = AIRBRAKE on
SWITCH D aileron dual rate
SWITCH E or G* Landing gear/ch5
SWITCH F or H* Snap roll /trainer
SWITCH G or E*
SWITCH H or F*
KNOB A
Flap/ch6
( flap trim if
FLAPERON on)
KNOB B ch 8
KNOB C Spoiler/ch7
(disabled if AIL-DIFF
on)
SLIDER D
1.1.3 Compatible Receivers
AT9S Pro is a 10 channels transmitter, support 2.4G DSSS and FHSS dual hybrid spread spectrum, 16
channels pseudo random frequency hopping.
AT9S Pro sells with receiver R9DS.
R9DS is a 9 channels receiver when working with PWM signal(red LED), it will a 10 channels receiver when
working with S-BUS signal(purple/blue LED).
Besides R9DS, AT9S Pro is also compatible with Radiolink R6DS, R10DS, R12DS and super mini 10
channels receiver R6DSM and 12 channels mini dual antenna receiver R12DSM.
R6DS, is a 6 channels receiver when working with PWM signal while it is a 10 channels receiver when
Sailplane/Glider
( GLID )
elevator dual rate
down=butterfly on
ch10
rudder dual rate
ch9
up = ELE-FLP on
center = Distance
cond.
down = Landing cond.
aileron dual rate
Trainer
——
up = Speed cond.
—— down = Start cond.
Flap/ch6
ch 8
ch 7
(disabled if AIL-DIF
on)
—— ch 5
Helicopter ( HELI ) MULTIROTOR
elevator dual rate
ch10
rudder dual rate
ch9
governor
aileron dual rate
——
Throttle hold/ch5
Trainer/throttle
cut
idle-up 1 and 2
idle-up 3 /gyro
HOVERING
PITCH
ch 8
HOVERING
THROTTLE
ch7
——
3
Radiolink Electronic Ltd
www.radiolink.com
elevator dual rate
ch10
rudder dual rate
ch9
attitude
aileron dual rate
——
trainer
——
——
ch 6
ch 8
ch 7
——