Model Type - RadioLink AT9S PRO Manual

Model type select
•ACRO basic:
Drive ACRO basic type (multi airfoil. Detail in Twin Aileron Servos, Twin Elevator Servos, ELEV-FLAP mix
and V-tail)
•glider:
Different tail type (detail in glider type)
•helicopter:
8 swash plate types (detail in helicopter type)
Caution: decide a model type for the model plane. To most fixed wing plane, aero basic is better,
because it has some function glider doesn't have. While sometimes, glider (2A+1F) is better.
•functions specially for aero basic:
•snap roll
•ELEV-flap mix (twin Elevator Servos support)
•oil power plane: idle down、throttle shut、throttle needle mix etc.
•functions aero basic doesn't have:
5 individual flight conditions (normal, start, speed, distance, landing)
If the model type selected for glider or helicopter, please go to the related chapter for setting. After
model type changed, all parameters need to reset, including name.

2.3.2 Model Type

Data reset
All set data can be reset to factory setting. This function will not delete all model type set in the radio.
Setup step:
Enter the basic menu for MODEL TYPE, use dial to choose a proper type and press PUSH for one
second, when the screen displays "are you sure", press PUSH and the radio will beep, and it is set to
factory data.
Caution: don't power the radio off before setting is finished, or the setting is invalid.
Model Select
Goals
Select proper Model
Type for your mode
l(Ex: ACRO)
Second aileron :( AILE-2) (ACROGLID1A+1FGLID2A+1F only): change the default choice for dual aileron
servos from channels 6(FLAPERON) to channels 5 and 6, or channel 3 and 6, or channel 7(AIL-DIF) to
channels 5 and 7. This allows you to utilize these 2 great functions while utilizing 5-channel receiver.
Caution: Changing AILE-2 only tells the system which servos to utilize if FLAPERON or AIL-DIF is
activated. You still must activate that function and complete its setup for details on twin aileron servos, including
using AILE-2.
(Only for glider 1A+1F) if the channel 3 is set as the second aileron, the receiver F/S will become invalid.
Steps
Open BASIC menu,
then PARAMETER
submenu
Go to MODEL TYPE.
Select proper type Ex:
ACRO Confirm the
change. Close.
Inputs
Turn on the transmitter. MODE for 1s.(If
ADVANCE, Mode again.
to Mode TYPE, press PUSH.
to ACRBASIC,PUSH for 1s. "Are you sure"
display. PUSH to confirm. End to BASIC menu.
16
Radiolink Electronic Ltd
www.radiolink.com