Acro Advance Function Menu - RadioLink AT9S PRO Manual

FLAPERON or AILE-DIFF programming. [This is beneficial with four aileron servos that need to have their
end points or sub-trims set separately. CH1, CH5 and CH6 are already fully set up to operate as ailerons. Mix
the CH7 or CH8 (the second aileron servo on the other side) into ailerons to function properly.
Goals
Adjust the 2 aileron servo
nd
output from CH6or7 to
channel CH6&5 Allow twin
aileron servos operating with
a 5-channel receiver.
There are 4 basic tail types in MULTIROTOR models:
• Simple. Model uses one elevator servo and one rudder servo (or multiple servos on a Y-harness). This is the
default.
• Dual Elevator servos. Model uses 2 elevator servos.
• Tail-less models. Model uses 2 wing servos together to create roll and pitch control. See ELEVON (ACRO/
GLID 1A+1F).
• V-TAIL. Model uses 2 surfaces, at an angle, together to create yaw and pitch control. see V-TAIL (ACRO/
GLID).
Note : Only one of the three tail-type functions (AILEVATOR, V-TAIL, and ELEVON) can be used at a time.
The radio provides a warming and will not allow the activation of another tail type until the first is deactivated.
An error message of OTHER WING MIXING IS ON will display.
Using ELEVON (ACRO/GLID 1A+1F): it is used with delta wings, flying wings, and other tailless
MULTIROTOR that combine aileron and elevator functions, using two servos, each one on the ELEVON. The
aileron/elevator responses of each servo can be adjusted independently. This is also popular for ground
model use, such as tanks, which drive two motors together for forward, and one motor forward/ one backward
for turning.

3.3 ACRO ADVANCE FUNCTION MENU

Mixes are special programs within the radio that command one or more channels to act together with input
from only one source, such as a stick, slider or knob.
There are a variety of types of mixes:
TYPE:
• Linear: Most mixes are linear. A 100% linear mix tells the slave servo to do exactly what the master servo is
doing, using 100% of the slave channel's range to do so. An example is FLAPERON, when aileron stick is
moved, the flap servo is told to move exactly the same amount. A 50% linear mix would tell the slave servo,
for example, to move to 50% of its range when the master's control is moved 100%.
• Offset: An OFFSET mix is a special type of linear mix. When the mix is turned on (usually a flip of a switch),
the slave servo is moved a set percent of its range. An example of this is AIRBRAKE, moving flaps,
FLAPERON, and elevator all to a set position at the flip of a switch.
• Curve: Curve mixes are mostly used in helicopters, but may also be used in airplanes and gliders. An
example is THROTTLE-NEEDLE mixing, where the in-flight needle's servo is moved, changing the mixture,
as the throttle servo is moved.
• Delay: Delay mixes are part of a few very special functions that make the servo move to its desired range
more slowly.
THROTTLE DELAY (simulates turbine engines) and the elevator delays in AIRBRAKE are two examples of
Steps
Open PARAMETER
submenu.
Select AILE-2 and change to
CH6&5.
Close
33
Radiolink Electronic Ltd
www.radiolink.com
Inputs
For 1s. (If ADVANCE
to PARAMETER ,PUSH
To AILE-2. to CH6&5
again) .