RadioLink AT9S PRO Manual page 56

This guideline is intended to help you get acquainted with the radio, to give you a jump start on using your
new radio, and to give you some ideas and direction in how to do with this powerful system.
Goals
Prepare your airplane.
Select the proper MODEL
TYPE for your model. (Ex:
GLID 1A+1F)
[NOTE: This is one of several
functions that require
confirmation to make a change.
Only critical changes such as a
MODEL RESET require
additional key strokes to accept
the change.]
Name the model
Note that you do not need to
do anything to 'save' or store
this data.
REVERSE servos as needed
for proper control operation.
Adjust travels as needed to
match model's recommended
throws (usually listed as high
rates).
Steps
Install all servos, switches, receiver per your model's instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly
centered. Mechanically adjust all linkages to get as close as possible to
proper control throws and minimize binding prior to radio set up.
Check servo direction and throws.
Make notes now of what you will need to change during programming.
In the BASIC menu,
open PARAMETER
submenu.
Choose proper MODEL
TYPE. Ex: GLID
(1A+1F).
Confirm the change.
Close submenu.
In BASIC menu open the
MODE SEL submenu.
Input airplane name.
Close the submenu.
In the BASIC menu,
open REVERSE.
Choose desired servo
and reverse its direction
of travel.
(Ex: reverse rudder
servo.)
In BASIC menu choose
END POINT.
Adjust the servos' end
points. (Ex: flap servo).
Close the function.
Choose D/R,EXP
51
Inputs
Turn on the transmitter.
BASIC.(If ADVANCE
PARAMETER.
to MODEL TYPE
GLID(1A+1F) for 1 sec. Are you sure?
Displays.
to c onfir m.
menu.
to MODEL SEL.
character of model's name is highlighted）.
to change the 1 st character.
to next character and repeat.
to REVERSE.
to 4.RUDD, REV is highlighted.
sec. 'Are you sure?' Displays.
To BASIC menu.
to END POINT.
to FLAP
VR(A). to desired travel.
，
VR(A). to desired travel.
，
Repeat as needed.
to D/R,EXP
Radiolink Electronic Ltd
www.radiolink.com
for 1 sec. to
again.) to choose
to
，
Return to BASIC
to NAME.（1
， st
to confirm.
to return.
for 1
to confirm.