Glider Model Functions; Set Basic Menu Of Glid - RadioLink AT9S PRO Manual

Goals
Activate
THROTTLE-
NEEDLE mixing.
Adjusting the points
as follows: to
resolve a slight lean
midrange problem:
1：40%
2：45%
3：65%
4：55%
5：40%
Please note that nearly all of the BASIC menu functions are the same for airplane (ACRO setup), sailplane
(GLID 1A+1F/ 2A+1F/ 2A+2F setups), and helicopter (HELI setups). The features that are identical refer back
to the ACRO chapter. The glider BASIC menu includes MOTOR CUT and does not include IDLE-DOWN or
THR-CUT.
○
→ Note: in all cases where ACRO programming labels channel 3 as throttle, GLID programming labels
channel 3 as ARB (airbrake), since airbrakes are normally operated on channel 3 in gliders. This includes
STK-THR reading STK-ARB.

4.1 SET BASIC MENU OF GLID

Steps
Open THROTTLE-NEEDLE
Activate the function.
HELI only. Select the condition
to edit.
Adjust the travels as needed to
match your engine by slowly
moving the stick to each 5
points, then adjusting the
percentage at that point until
the engine is properly tuned.
ACRO only . Optional: increase
mixture when throttle is applied
rapidly-ACCE.(see above for
details)
Heli only: set curves for another
conditions.
Close
PART 4 GLIDER MODEL FUNCTIONS
Inputs
to BASIC . again to ADVANCE
to THR-NEEDLE,
to MIX.PUSH
to COND.PUSH.
to PIONT.
Throttle Stick to P 1，
Throttle Stick to P 2，
Throttle Stick to P 3，
Throttle Stick to P 4 ，
Throttle Stick to P 5，
to ACCE. Push
Throttle Stick to full open quickly.
to condition name
edit.
Repeat above steps as needed.
50
Radiolink Electronic Ltd
www.radiolink.com
to ON.
as needed.
to 40%，
to 45%，
to 65%，
to 55% ,
to 40%,
Throttle Stick to idle
to next condition name to