Start Delay (Glid 1A+1F Only) - RadioLink AT9S PRO Manual

These additional flight conditions contain different offset trims to
make the sailplane perform certain maneuvers more easily.
Aileron differential functions may be set to provide separate rates
per condition selected.
Prior to setting up OFFSET, you must active the conditions and
assign the switches in the CONDITION/FUNCTION.
Unnecessary fuselage motion is generated when there are
sudden changes in the servo position and variations in the
operating time between channels can be suppressed by using the
delay function.
Note: The same delay amount for elevator and rudder is recommended when using V-tail function.
The AT9 provides 5 additional setups along with the normal flight condition. (NORMAL,
START, SPEED, DISTANCE and LANDING) These offset trims have same setting abilities basically except
the switch and dial assignment. For an example of trim settings, please see the following:
Adjustability:
• Separate adjustments for each aileron, elevator, rudder and flap servo, for each condition.
• SWITCH G (AT10) or E (AT10) is programmed for NORMAL, START, and SPEED trims. SWITCH C is
programmed for DISTANCE and LANDING trims. These switch/position assignment is adjustable.
(CONDITION/FUNCTION)
• TRIM item (Digital trim operation mode):
NORM: normal trim operation mode.
MIX: offset rate trim operation mode while mixing is on.
• Optional assignable knob (CAMBER MIX) to allow trimming in flight of the aileron and flap action of each
flight condition.
• During OFFSET operation, the aileron and elevator travels are displayed on each trim display in the Startup
screen.
Goals
Set up a START to gain
maximum possible lift on
launch.
Each Aileron: 50%. Each Flap:
100%.
Elevator: -5% to compensate.
SWITCH (AT9=G, AT9=E.)
Note: switch is assignable.
(CONDITION)
KNOB(null)
Note: knob is assignable.
(CAMBER MIX)

4.3.5 START DELAY (GLID 1A+1F only):

START DELAY automatically switch the offset trims (OFFSET) from the
START condition's trims to the normal condition's trims after proceeding
the delay time (max.10sec.) which is set by the -DLY- item when
activating the START condition. (It is convenient for hand launch glider.)
Note: The same delay amount for elevator and rudder is
recommended when using V-tail function.
Steps
Open OFFSET function
Switch to the START condition.
Set the rates. (Ex: AIL 50%,
FLP 100%, ELEV -5 %.)
Close
54
Radiolink Electronic Ltd
Inputs
to BASIC . again to ADVANCE
to OFFSET,
G or E from NORMA to START
to AIL to 50%,
，
Repeat for FLP and ELEV.
www.radiolink.com