Steering Speed "Stspd; Throttle Exponential "Thexp - RadioLink RC6GS V2 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
0%~+100%: Sensitivity around neutral position is high, getting lower when approaching ends
Steering operation curve adjustment
(1) Access the function menu (By pressing "Exit" and "Enter "buttons simultaneously and holding them down
for one second ), press "Inc(+)" button three times to chose EAP function.
(2) Press "Enter" button to get into STEXP function interface, press "Enter"key and the initial value of the rate
will blink, then you can press "Dec(-) "or "Inc(+)"button to adjust the value and the curve of the rate shown in
the figure will change correspondingly.
(Note: In the interface of adjusting the value, return to the initial value "0%" by pressing "Dec(-)" and"Inc(+)"
buttons simultaneously for about 1 second.)
(3) Press "Enter" button, the adjusted value of the rate stops blinking, now the value of the rate has been set.
(4) Return to the initial screen by pressing"Exit" button twice.
Note: the Vertical cursor shown in the figure moves in step with steering wheel operation.

2.6 Steering Speed "STSPD"

Quick steering operation will cause momentary under steering, loss
of speed, or spinning. This function is effective in such cases.
Setup item
TURN: turn direction
RETURN: return back to the original direction
Adjustment range
0%~100% (each direction)
At 100%, there is no delay
Steering servo delay
(1) Access the function menu (By pressing "Exit" and "Enter" buttons simultaneously and holding them down
for one second), press "Inc(+)" button four times to chose STSPD function.
(2) Press"Enter" button to get into STSPD function interface, press "Dec(-)" or"Inc(+)" button to select setup
item, then press "Enter" key and the initial value of selected setup item will blink.
(3) Use"Dec(-)" or "Inc(+)" button to adjust the value of the selected setup item.
(Note : In the interface of adjusting the value, return to the initial value "100%" by pressing"Dec(-)" and"Inc(+)"
buttons simultaneously for about 1 second.)
(4) Press "Enter"button, the adjusted value of the selected setup item stops blinking, now the value of the
selected setup item has been set.
(5) Return to the initial screen by pressing "Exit" button twice.

2.7 Throttle Exponential "THEXP"

This function makes the throttle high side and brake side direction servo operation quicker or milder. It has no
effect on the servo maximum operation amount. For the high side, selection from among three kinds of curves
(CRV/VTR/EXP) is also possible.
The curve can be divided into: Five dots throttle curve adjustment, Single point adjustment,
Exponential curve adjustment, Braking index curve adjustment. To elevation point,
we can select(Exponential curve/Single point curve/Five points curve).
Curve point adjustment(select five points 1-5)
(1) Press"Enter" button,The curve point value start flashing,then press"Dec(-)"and"Inc(+)" button to adjust the
9