RadioLink AT9S PRO Manual page 66

Select proper mode
type for your model.
Ex: HELI H-1
Then , NAME the
model.
Goals
Reverse servos as needed
for proper control operation.
Ex: Left Rudder Stick results
in leading edges of tail rotor
blades moving left. Reverse
to operate properly.
Adjust travels as needed to
match model's recommended
throws.(usually listed as high
rates.
Activate THR-CUT.
In the BASIC menu, find
PARAMETER.
G o to MO DEL TYP E .
Select proper mode type. Ex:
HELI H-1. Confirm the
change.
Close.
In the BASIC menu, find
PARAMETER.
Go to MODEL SEL.-NAME
Input name.
Close the submenu when
done.
Steps
In BASIC menu, open
Reverse.
Choose desired servo and
reverse its direction of travel.
Ex: reverse rudder servo.
In BASIC menu, choose
END POINT.
Adjust the servo's end
points. (Ex: elevator servo).
Return to BASIC menu.
Open THROTTLE-CUT
function.
Activate the function. Choose
desired switch and position
to activate.
With THROTTLE STICK at
idle, adjust the rate until the
engine consistently shuts off,
but throttle linkage is not
binding.Close
for 1s to BASIC.(If ADVANCE
to PARAMETER ,PUSH
to MODEL TYPE, then to TYPE.
to HELICOPTER.
displays ， to SWASH
1sec,'Are you sure ?' displays.
to MODEL SEL.
to Name(1 st character is highlighted)
to change the first character.
When proper character is display.
Inputs
for 1s to BASIC.(If
ADVANCE
to REVERSE ,
to CH4:RUDD
highlighted. 'Are you sure ?' displays
for 1 sec.
to END POINT
point.
to ELEV.
up travel is as desired.
Stick
，
desired.
Repeat as needed.
to THR CUT
to MIX,
to SW
to POSI
SwC to down position，
Stick ，to RATE
61
Radiolink Electronic Ltd
www.radiolink.com
again) .
for 1 sec. 'Are you sure?'
,
to H-1
to confirm.
to next. Repeat.
again) .
to REV is
，
to choose end
Elevator Stick ， until
Elevator
until down travel is as
to OFF
，
， to SwC,
to DOWN,
，
Throttle
until shuts off.
，
for