Swash-Ring; Throttle Needle (In Acro 3.3.15) - RadioLink AT9S PRO Manual

Goals
Correct the
tendency of the
model to change
altitude.

5.3.11 SWASH-RING

This function is to limit movement of swash plate to avoid damage to the SWASH ROB during operation
aileron and ELEVATOR. It is affected in 3D flight. Movement of AILERON and ELEV is limited in the circle.
Adjustability:
• Initial: 100%
• adjusting
0-200%
Goals
To prevent damaging the swash
linkage by simultaneous operation
of the ailerons and elevators, set
the limit point where swash throw
stops.
＊Adjust the rate at the maximum
swash tilt by simultaneous
operation of the ailerons and
elevators.
5.3.12 THROTTLE NEEDLE (see ACRO MENU 3.3.15)
5.3.13 PROG MIX (see ACRO MENU 3.3.1)
Steps
Open THRO- MIX function.
Activate the function.
Adjust the rate.
Ex: IDL1 (AIL to TH) 10%
Repeat as needed.
Close
Steps
Open SWASH-RING
function.
Activate the function.
Adjust the rate Ex: 90%
Close
Inputs
to BASIC menu,
to THRO-MIX
to MIX
，
to IDL1 (AIL→TH)
Inputs
to BASIC menu,
ADVANCE
to SWASH-RING
to MIX
to RATE
74
Radiolink Electronic Ltd
www.radiolink.com
again to ADVANCE
to ON
to 10%,
，
range:
again to
to ACT
，
， to 90%，