Connecting The Teaching Box - Omron C200H-MC221 Operation Manual

Connecting the Teaching Box

8-3

Connecting the Teaching Box

Connecting Cable
Connecting to the MC Unit
1, 2, 3...
68
This section explains how to connect the Teaching Box and MC Unit.
Use the connecting cables shown in the following table to connect the Teaching
Box to the MC Unit.
Model
CV500-CN224
CV500-CN424
CV500-CN624
Note A personal computer or the Teaching Box can be connected to the peripheral
device connector of the MC Unit. A personal computer and the Teaching Box
cannot both be connected to the peripheral device connector at the same time.
1. To display messages in Japanese on the Teaching Box, set pin 2 of the DIP
switch on the MC Unit's rear panel to OFF.
2. Remove the connector cover.
Use a small standard
Cover
screwdriver or similar
object to open the cover.
3. Insert the cable connector into the Teaching Box.
Section 8-3
Cable length
2 meters
4 meters
6 meters
DIP switch
ON
The cover that has been re-
moved can be attached to the
back of the Unit for convenience,
to keep it from getting lost.
Cover retained
Make sure that the connector is
facing in the proper direction,
and then snap it into place.