Starting Up The Pc; Setting Parameters - Omron C200H-MC221 Operation Manual

Setting Parameters

8-7

Starting Up the PC

1, 2, 3...
8-8

Setting Parameters

74
After the switch box has been prepared, wire it to the Input Unit as shown below.
0
1
2
3
4
5
C200H-
6
ID212
7
8
to
15
COM
This section explains how to set the program type and the PC model, and how to
create the I/O table. These settings must be made when first mounting the CPU
and MC Unit to the CPU Backplane.
It is assumed here that the SYSMAC Support Software has already been
installed. Refer to the relevant sections of the SYSMAC Support Software Op-
eration Manuals for explanations of installation operations.
1. Start up the SYSMAC Support Software and set the PC model to the follow-
ing: C200HE-CPU11-E
2. Switch the SYSMAC Support Software to online mode.
3. Create the I/O table according to the status of the Units that are mounted to
the Backplane.
4. Return the SYSMAC Support Software to offline mode so that the ladder-
diagram program can be created.
This section explains how to set the parameters that are necessary for control-
ling the MC program. (8-12 Creating the MC Program explains how to create the
program.)
Set the parameters by changing some of the default values for the MCSS. After
the parameters have been set, transfer them to the MC Unit.
Section 8-8
Switch Box
Manual
Automatic
Operation
Start
Origin
X+
X--
Y+
Y--
24 VDC