Table of Contents
Advertisement
M3A Vital Signs Monitor User Manual
tap water after cleaning until no visible cleaning agent remains.
4.
Wipe off with a dry cloth to remove residual moisture
5.
Air dry the cuff thoroughly after cleaning.
Replacing the Air Bladder:
After cleaning, replace the air bladder into the cuff following the steps below:
1.
Roll the bladder lengthwise and insert it into the cuff from the large opening at one end of
the cuff.
2.
Thread the hose from within the cuff and out through the small hole at the top of the cuff.
3.
Adjust the bladder until it is in position.
7.3.2.2 Cleaning the SpO
1.
Wipe the surfaces of the sensor and cable using a soft cloth dampened with the cleaning
solution until no visible contaminants remain.
2.
Wipe the patient contact area of the sensor with the cotton swab dampened with the cleaning
solution. until no visible contaminants remain
3.
After cleaning, wipe off the cleaning solution with a fresh cloth or towel dampened with tap
water until no visible cleaning agent remains.
4.
Wipe off residual moisture with a dry cloth.
5.
Leave the sensor to air dry.
7.3.2.3 Cleaning the TEMP Sensor
1.
Wipe the patient contact area with a soft cloth dampened with the cleaning solution until no
visible contaminants remain.
2.
Wipe off the cleaning solution with a fresh cloth or towel, dampened with tap water after
cleaning until no visible cleaning agent remains.
3.
Wipe off residual moisture with a dry cloth.
4.
Leave the sensor to air dry.
7.3.3 Cleaning the Dust-proof Filter Assembly
The dust-proof filter system is shown as below figure. Through filtering the dust in air and the
abnormal objects during deflation, the dust proof filter system can extend the pump's lifetime and
reduce the effect of dust on measurement accuracy.
Sensor
2
- 45 -
Maintenance and Cleaning
Advertisement
Table of Contents
