Table of Contents
Advertisement
M3A Vital Signs Monitor User Manual
2
Do not leave the recorder door open unless when replacing paper or removing fault.
Removing Paper Jam
If the recorder works improperly or produces unusual sound, open the recorder door and check
whether there is a paper jam. If yes, remove it following the procedure below:
1.
Cut the paper from the feeding edge.
2.
Open the recorder door.
3.
Reload the paper and close the recorder door.
6.3.2 Outputing the Monitoring Data
By selecting the items on Main Menu > Recorder, you can output the real time data, trend graph
current trend table and history trend table.
Record Realtime Data: Select this item, and the recorder will output the real time data
including measurements and SpO
Record Trend Graph: Select this item, and the recorder will output the trend graph.
Record Current Trend Table: Select this item, and the recorder will output the current
trend table.
Record History Trend Table: Select this item, and the recorder will output the history trend
table.
Press the buttom UP or DOWN on the front panel to select an item among the above-mentioned
items from the menu, and press
recorder will start outputting the monitoring data. Meanwhile, the selected item will be changed
into Stop Record.
You can stop the current recording process by select Stop Record on the menu.
NOTE:
Do not use the recording function when a low battery alarm occurs, or automatic
shutdown of the monitor may result.
6.3.3 Recorder Alarm Information
Technical Alarm:
Message
Recorder Out Of
Paper
No Recorder
waveforms.
2
Cause
Recorder Out Of Paper
The
user
presses
RECORD button when
Recorder
is
configured.
on the front panel to confirm it. Subsequently, the
Alarm Level
Low
the
Low
not
- 42 -
Trend and Recording
What to do
Please install the paper.
Notify the manufacturer's
service staff to install and
set the recorder.
Advertisement
Table of Contents
