EDAN M3A User Manual page 70

M3A Vital Signs Monitor User Manual
Technical alarms: (display in the area below the NIBP value):
Message
NIBP COMM
STOP
NIBP INVALID
RESET
NIBP MODULE
ERR
LOOSE CUFF
AIR LEAK
AIR
PREESURE
ERR
NIBP SIGNAL
TOO WEAK
NIBP NOISY
SIGNAL
OVER
PRESSURE
NIBP
SELFTEST
ERR
CUFF TYPE
ERR
Cause
NIBP module failure or
communication failure.
The hardware pressure
is too high
The NIBP module has
failure.
Cuff is no properly
wrapped or no cuff
exists.
NIBP pump, valve, cuff
or tube has a leakage.
The airway of NIBP has
failure.
Cuff is too loose or
patient pulse is too
weak.
Because of arm motion,
signal noise is too large
or pulse rate is not
regular.
Pressure has exceeded
the specified upper
safety limit.
When the monitor is
powered on, NIBP
module is detected to
fail in calibration.
Cuff type does not
comply with the patient
type.
Alarm
Level
Stop using measuring function of
NIBP module; notify biomedical
High
engineer
service staff.
High Measure again, if failure persists,
stop using measuring function of
NIBP
biomedical
High
manufacturer's service staff.
Low Properly wrap the cuff.
Low
Check and replace the leaking
parts,
biomedical
manufacturer's service staff.
Low
Use other method to measure
Low
blood pressure.
Make sure that the patient under
Low
monitoring is motionless.
Measure again, if failure persists,
stop using measuring function of
Low NIBP
biomedical
manufacturer's service staff.
High Contact your service personnel.
Low Select appropriate cuff type
- 63 -
NIBP Monitoring (Optional)
What to do
or manufacturer's
module and notify
engineer
if required, notify
engineer
module and notify
engineer
or
or
or