EDAN M3A User Manual page 14

M3A Vital Signs Monitor User Manual
8 If the monitor gets damp, put it in dry circumstance to dry it until it can work normally.
If liquid pours on the monitor, please contact the service personnel authorized by
EDAN.
9 Avoid liquid splash and excessive temperature. The working temperature must be
kept between 0 C and +40 C, and it is recommended to be kept between +10 C
and +40 C when the monitor is equipped with TEMP module. The temperature
should be kept between -20 C and +55 C during transportation and storage, and it is
recommended to be kept between -20 C and +50 C when the monitor is equipped
with TH module.
10 Remove a battery whose life cycle has expired from the monitor immediately.
11 A potential hazard may exist if different alarm presets are used for the same or similar
equipment in any single area.
12 Assembly of the monitor and modifications during actual service life shall be
evaluated based on the requirements of IEC60601-1.
13 Poor connection might be caused by frequently plugging and unplugging the power
cord. Check the power cord regularly and replace it in time.
NOTE:
1 The monitor can only be used on one patient at a time.
2 Position the device in a location where the operator can easily see the screen and
access the operating controls.
3 This equipment is not intended for home usage.
4 If the device is discolored or damaged, then discontinue use of the device.
5 The pictures and interfaces in this manual are for reference only.
6 Regular preventive maintenance should be carried out every two years. You are
responsible for any requirements specific to your country.
7 The materials with which the patient or any other person can come into contact
conform to the standard of EN ISO 10993-1: 2013.
8 When there's measurement beyond range, invalid measurement or no measurement
value, it will display "---".
9 To protect eyes from damage, don't look directly at supplementary light for long time.
10 Make sure networking function is used in a secure network environment.
11 In normal use, the operator shall stand in front of the monitor.
Intended Use and Safety Guidance
CAUTION
- 7 -