The Device Does Not Go To Setting Mode After Inputting Master Id; A Master Id May Have Changed; The Device Work Well With Rf Card, But Does Not Work When Inputting Card Number; Please Check If Keypad Is Set To "Use - IDTECK FINGER007 Manual

4 The device does not go to setting mode after inputtin
g MASTER ID.
4.1

A MASTER ID may have changed.

1. Change the MASTER ID from software and transmit it to the device.
2. If you cannot change MASTER ID using software, see
3. [Installation of the product] > [System Initialization] and initialize the device.
Once you initialize the device, MASTER ID of the device goes back to 00000000 (8
digits). In the case of SR model, MASTER ID goes back to 0000000000 (10 digits).
If the problem persists, please contact service center.
5 The device work well with RF Card, but does not work
when inputting card number.
5.1

Please check if Keypad is set to "USE".

The default of the keypad input is "NOT USE".
1. See [Setting Changes] > [Setup Menu F2] > [RF PIN input] of the manual and set it to
"USE".
If the problem persists, please contact service center.
p.89 Troubleshooting