Master Id Registration - IDTECK FINGER007 Manual

Proper selection of this setting depends solely on whether Reader 2 uses password
verification, but it has nothing to do with whether Reader 2 uses fingerprint verific
ation or not
1.6

Master ID Registration

Master ID is the number/card that you use to enter the Setup Mode. For security reasons, it i
s advisable that you change the default Master ID immediately and keep the new Master ID
/ card confidential.
Beware that if you forget the Master ID, you cannot access the Setup Mode.
To change the Master ID, press <ENT>, and then either enter the desired 8Digit Master ID or
present a card to the reader.
For the FINGER007SR, the Master ID is 10Digits long in the range of 0000000000
to 4294967295.
On the next screen, enter the desired 4Digit Master Password in the PW field and, in the FP
field, enter <0> if you wish to access Setup Mode without master fingerprint verification or
<1> if you wish to use master fingerprint, in which case you will be asked to place your finge
rprint on the scanner twice in the next step. When the Master ID/card registration is successf
ully completed, the LCD displays the "REGISTRATION OK" message.
The default Master ID for FINGER007/P and IP-FINGER007 is 00000000 (Eight zero
s), but for the FINGER0007SR, it is 0000000000 (Ten zeros)
Setup Menu F1 p.48