When Configuring The Device Using Master Id, Suddenly The Device Goes Back To The No Rmal Mode; If You Do Not Input Anything For 60 Seconds In Setting Mode, The Device Goes Back To The Normal Mode; The Device Does Not Go To Setting Mode After Inputting Master Id; A Master Id May Have Changed - IDTECK Star iCON100SR User Manual

If the problem persists, contact service center.
3 When configuring the device using MASTER ID, sudde
nly the device goes back to the normal mode.
3.1 If you do not input anything for 60 seconds in setting mode, the device goes
back to the normal mode.
To prevent the setting from being changed by one who is not a manager, when the manage
leaves the device in setting mode, the device goes back to the normal mode when there is n
o input for 60 seconds.
4 The device does not go to setting mode after inputtin
g MASTER ID.
This is for when using LCD and Keypad modules with the device.
4.1

A MASTER ID may have changed.

1. Change the MASTER ID from software and transmit it to the device.
2. If you cannot change MASTER ID using software, see [Initial setup] > [Initialization of iC
ON100] or [Setting changes] > [Setup menu F2] > [System Initialization] of the manual
and initialize the device.
Once you initialize the device, MASTER ID of the device goes back to 00000000 (8
digits). In the case of SR model, MASTER ID goes back to 0000000000 (10 digits).

The device does not go to setting mode after inputting MASTER ID.

p.79