Output Time Setting - IDTECK FINGER007 Manual

press <ENT> again. After the cursor appears, enter the 10Digit number for the desired settin
g. Once all information is entered, press <ESC> to exit.
The range of values you can enter in each field is as follows;
1-14, 17-18: 00 – 99 (Output Signal Time)
15-16: 00-10 (Time Schedule Code)
19-21:" Enable" or" Disable"(Selecting "01" is "Enable", Selecting "00" is "Disable")
The 10.Duress mode setting allows you to decide the output signal time for when
access is granted following a duress event.
When a particular event occurs, the FINGER007 will generate an output signal for
Relays #1 and #2, TTL #1 and #2, and Buzzer for the length of time defined for eac
h.
2.6

Output Time Setting

Output Time Set allows you to define the unit of time.
1 sec
Output Time is calculated in the time unit of 1 second for the In/Output definition.
0.1 sec
Output Time is calculated in the time unit of 1/10 second (or 100ms) for the In/Outp
ut definition
To change the setting, press <ENT> and press <4> or <6> to select the desired time unit and
press <ENT> to confirm.
p.57 Setting Changes