When Configuring The Device Using Master Id, Suddenly The Device Goes Back To The No Rmal Mode; The Device Does Not Go To Setting Mode After Inputting Master Id; A Master Id May Have Changed - IDTECK LX007 Manual

If the problem persists, please contact service center.
3 When configuring the device using MASTER ID, sudde
nly the device goes back to the normal mode.
3.1 If you do not input anything for 60 seconds in setting mode, the device goes
back to the normal mode.
To prevent the setting from being changed by one who is not a manager, when the manage
leaves the device in setting mode, the device goes back to the normal mode when there is n
o input for 60 seconds.
4 The device does not go to setting mode after inputtin
g MASTER ID.
4.1

A MASTER ID may have changed.

1. Change the MASTER ID from software and transmit it to the device.
2. If you cannot change MASTER ID using software, see
X007] and initialize the device.
Once you initialize the device, MASTER ID of the device goes back to 00000000 (8
digits). In the case of SR model, MASTER ID goes back to 0000000000 (10 digits).
If the problem persists, please contact service center.
p.90 Troubleshooting
[Basic setting] > [Initialization of L