Table of Contents
Advertisement
Hydraulic Control Panel
Light/Remote Switches
The LIGHT/REMOTE SWITCH panel is located on the
driver's side of the power control center (See Figure 3-3.)
1. The first and second toggle switches nearest the
front of the trailer operate the front and rear beacon
lights.
2. The third and fourth switches control the front and
rear under deck lights.
3. The fifth switch is used to activate the bumper strobe
lights.
4. The sixth switch activates the remote.
Backup Alarm and Lights
The BACKUP ALARM AND LIGHTS are activated after
eight inches of reverse travel and remain on while the
trailer is moving in reverse. Backup alarm and lights will
shut off five seconds after the trailer has stopped or is
moved forward.
Chain Control Lever
The CHAIN CONTROL lever (See Figures 3-1 and 3-3)
is located on the driver's side of the power control center.
The lever has three positions:
In this position, the chain pulls toward
FORWARD
the front of the trailer.
(UP)
CENTER
This is the neutral position. The chain
stays in its current position.
In this position, the chain pulls toward
REARWARD
the rear of the trailer.
(DOWN)
Outrigger Sideshift Control Levers
The OUTRIGGER SIDESHIFT CONTROL levers (See
Figures 3-1 and 3-3) are located on the driver's side of
the power control center.
The outrigger valves are positioned to allow for ease of
sideshifting the trailer. The front outrigger levers will be
pulled up to allow streetside outrigger to retract while the
curbside outrigger extends. The front outrigger levers will
be pushed down to allow streetside outrigger to extend
while the curbside outrigger retracts.
The rear outrigger valves operate in the same manner as
the front.
Individual operation of the outriggers can be controlled by
each single lever.
OPERATING INSTRUCTIONS
Trailer Lift Control Levers
The TRAILER LIFT CONTROL levers (See Figures 3-1
and 3-3) are located on the driver's side of the power
control center. There are four levers controlling the height
of the mechanical outriggers on each side of the
semitrailer.
When using hydraulic outriggers, the semitrailer
must be kept level at all times. Do not lower the
parking stands. Loads being placed on the
semitrailer must be kept centered on the
semitrailer. An unlevel semitrailer may allow a
load to slide, causing injury or death to anyone
near the load!
Each lever has three positions:
In this position, the corner of the trailer
UP
will raise. There is a lever designated
for each leg.
CENTER
This is the neutral position. The
semitrailer stays in its current position.
In this position, the corner of the trailer
DOWN
will lower. There is a lever designated
for each leg.
Axle Control Lever
The AXLE CONTROL lever (See Figures 3-1 and 3-3)
is located on the driver's side of the power control center.
The lever has three positions:
In this position, the axle moves toward
FORWARD
the front of the trailer.
(UP)
CENTER
This is the neutral position. The
semitrailer stays in its current position.
In this position, the axle moves toward
REARWARD
the rear of the trailer.
(DOWN)
DANGER
3-9
Advertisement
Table of Contents
