Fasteners
After a few hours of use check entire machine and tighten any loose nuts or bolts. Daily or periodic checks
should be made thereafter.
Tires For Dual Wheel Pulverizers
Recommended size of four tires are: 9.5L x 15 6 ply inflated to 24 psi
Lubrication
Grease zerk fittings daily. Locations are:
Transport axle bearings (bottom) ------------------- 3
Hinge pins ------------------------------------------------ 4 (2 per hinge)
The above items are not sealed and cannot be overgreased.
Wheel bearings should be repacked annually.
When Pulverizer is not used for some time, exposed cylinder rods should be cleaned and covered with a thick
coat of grease. This will prevent corrosion which will damage seals.
683rev501
MAINTENANCE
Page 8
6J862